CARE INSTRUCTIONS & DISINFECTION
IMPORTANT: Protect the filter and electronics from moisture and direct contact with cleaning agents / water! For this reason, always remove the respiratory filters before cleaning.
Treatment with agressive cleaning agents or cleaning agents / disinfectants containing alcohol (with an alcohol content of more than 20%) is expressly discouraged. These can damage the special coating of the anti-fog pane and thus cause premature fogging (saturation e ect). Instead, we recommend cleaning the mask body and pane under soapy running water and allowing it to air dry (min. 30-60 minutes). High-temperature treatment (max. 55°C) is also not recommended, as this can lead to unwanted deformation of the mask and pane.

Method: Soapy running water / normal temperature

Remove both respiratory filters and disconnect the cable from the pane first.
See instructions Replacing/fitting the respiratory filters in reverse order (7 – 1).

Clean the mask body and pane using soapy water and rinse under running water.

Pay special attention to the face flange and inside areas of the mask body.
Method: Using disinfection liquid / low alcohol content

Remove both respiratory filters and disconnect the cable from the pane first.
See instructions Replacing/fitting the respiratory filters in reverse order (7 – 1).

Use a soft, clean cotton or microfibre cloth. First, spray the cleaning agent onto the cloth and use it to clean the mask body and pane.
Note: alcohol content no higher than 20%.

Pay special attention to the face flange and inside areas of the mask body.